Comment on how to get more arduino analog inputs by andrew
Hi, The loop function “void loop()” is where the guts of any arduino code goes. It simply loops through its instructions continually while the arduino is powered up. So what you need to do is hook up...
View ArticleComment on how to get more arduino analog inputs by C#Bb
Took me all night but here’s my understanding; special thanks to Andrew Burrell Edited cy Caesar Passee MUx A edited by pitchoilcan at geemail dot com void setup() { //4051 digital control pins...
View ArticleComment on how to get more arduino analog inputs by andrew
hi.. There were some syntax errors in your code, but the following, assuming your hardware is wired up correctly, should work for you to read all 8 analog inputs of the 4051 from analog pin 0 on the...
View ArticleComment on how to get more arduino analog inputs by Constantine
Hi, I was wondering if this setup means that it would not be possible for arduino to read the input of 2 analog pins on the multiplexer at the same time. For example, if I connect 2 potentiometers to 2...
View ArticleComment on how to get more arduino analog inputs by andrew
It is not literally possible to read more than one of the multiplexer’s pins at once, but the loop happens so fast that you can turn the two (or more) pots at once and it will read them in turn but...
View ArticleComment on Fledgling Virtual Environments in Unity by Michela
Good to read up on your stack! Thanks for posting.
View ArticleComment on how to get more arduino analog inputs by David Early
I have a requirement for 10 analog input for photocells. Any ideas on this? What additionalo IC to use for this? Thanks, Dave
View ArticleComment on kinect –> openFrameworks –> Syphon –> max/msp/jitter by Gerry
sadly this doesn’t seem to work with open frameworks 007.
View ArticleComment on how to get more arduino analog inputs by andrew
Hi Dave, Sorry I missed your question back on September. For more than 8 analogue inputs, there are two solutions I can think of. One would be to use two multiplexer ICs on 2 separate arduino pins, or...
View ArticleComment on how to get more arduino analog inputs by Trent
Hi Andrew, I build a controller with 32 pots connected to 4 multiplexers. I was wondering if you know how to properly transform these signals into a MIDI message. At the moment I can see all the pot...
View Article
